Forum Topics

MANUAL SLIDE RETRACTION

by
CATEGORY:  SLIDE-OUTS & COMPONENTS

TOPIC:   MANUAL SLIDE RETRACTION
Posted: 7:21 PM – Oct 03, 2018 #1
Posted By:  msw3113

See Forum Post HERE

Inkedview thru hatch_LI.jpg

msw3113: 

The Bad News:  Larger slide will not retract under power.  Motor spins, a rapid thumping noise is heard, but slide won’t move.  The last time it retracted under power there was a loud thump and the slide stopped about 1/4″ away from fully closed.  It opened normally but now won’t move.
The Good News:  it’s in my driveway.
Bad News:  Until the slide gets retracted I can’t tow the unit anywhere to have it repaired.

Read more

UNDERPINNING MATERIAL SAGGING/LOOSE

by

UNDERPINNING MATERIAL SAGGING/LOOSE

RandyTeague: Anyone having this issue? I have used Gorilla tape to put it back up. Temp fix I know. Already falling again. Was thinking rubber coating brushed on would help this issue. What are your thoughts on this?

Alloy: Flex-Mend or Mobile Home Underbelly tape. Surfaces have to be clean. Check that the zipper still works before taping things up.

JohnD222: This is the glue-on zipper access panels.  This is not uncommon.  Clean all surfaces with 99% Isopro alchohol  a lot is only 45%, and has residual that prevents glues from bonding.  Most gorilla tapes need pressure to get them to set.  Apply that pressure with the zipper open where you can get on both top and bottom, then close.

LOOSE SCREWS – REPAIR FAC. NEAR N.H.

by
CATEGORY:  ON THE OUTSIDE

TOPIC:   Repair Facility Needed Near N.H.
Posted: 16 Sep 2018 17:19 #1
Posted By:  msw3113

See Forum Post HERE

msw3113: Screws that hold the trim on one corner of the “chin” area of our Cameo are popping loose and won’t screw back in.  Trim piece therefore won’t stay fastened to sidewall.  Underneath, the edge of the horizontal sheet metal in that corner is becoming exposed.  I fear that our unit has fallen prey to the often-discussed fault of the brand. Even the work involved in taking the trim and sheet metal apart to inspect what

Read more

error: Content is protected !!
Close

Pkg. download step by step

  • 1. Click on the Download link provided below.
  • 2. A browser tab will open showing your download in .zip format with the download button.
  • 3. Click the download button.
  • 4. The .zip file will appear in a pop-up winow. Click the "Save" button in the lower right corner of the popup.
  • 5. You may see a brief pop-up notice that you can click on to open the file or you can go to your "Downloads Folder" in your File Explorer.
  • 6. In the File Explorer window, your download will appear at the top of the list of downloads.
  • 7. Left click to "Highlight" the file.
  • 8. In the Header of the window, you'll see "Extract All"... A pop-up will appear, you can click "Extract" button to extract and save to the default location shown in the pop-up and open it from there or you can click on the "Browse" button and choose your preferred location to save it.
  • 9. Click on the "Extract" button.
  • 10. Once Extracted, you can open and view the file.