- This topic has 0 replies, 1 voice, and was last updated 5 years, 10 months ago by
CLOC-Admin.
CLOC-Admin.- Topic
- CLOC-Admin
Ems-hw50c Progressive Industry surge protector
https://carriage-lifestyle-owners.com/viewtopic.php?f=24&t=4106
Posted: 12:18 PM – Mar 02, 2019Just bought one of these to add to cameo, found a perfect spot in the basement to install under steps and wire runs straight up to breaker box , my question is do these surge protectors make any noise , if so may want to find different location to mount , but this location is perfect for accessibility and where power cord is , suggestions ?Sent from my iPhone using Tapatalk
Posted: 1:24 PM – Mar 02, 2019Ours in the rear basement right where the shore power cable comes in. I removed the interior panel to access the back side of the power
cord and placed it in that area and then put the panel back.
No, they only make a heavy click once energized. Good choice and good luck. PhilPosted: 1:49 PM – Mar 02, 2019jdpm wrote:Ours in the rear basement right where the shore power cable comes in. I removed the interior panel to access the back side of the power
cord and placed it in that area and then put the panel back.
No, they only make a heavy click once energized. Good choice and good luck. PhilAre you talking about the rear panel on the side at rear door ? Mine has some tv cables attached to it also , didn’t know if it came out easy or not
Sent from my iPhone using Tapatalk
Posted: 1:54 PM – Mar 02, 2019Yes, I assume you have the rear trunk/basement with a compartment door on each side. My plug on the former Cameo and the LS is on the left side rear just forward of the compartment door.
The panel is easily removable. While hard to see, its held in place by screws that are sort of concealed by the marine carpet.
In our case, its a great spot for it as it was otherwise dead space.Posted: 2:02 PM – Mar 02, 2019Ok thanks for info , I will look at that option also , I have the 35sb3 the panel in the big storage compartment moves easy also and the power cord has a big loop in it there , I don’t have generator prep , so no transfer box , that was where I was thinking if it didn’t make a humming noise , then thought about putting monitor inside panel where slide switches are , it is strait up from there easy accessSent from my iPhone using Tapatalk
Posted: 9:47 AM – Mar 07, 2019Going to install in a few days when weather gets better , comes from factory with a 15 second delay but can be extended , my question do most use factory setting or extend time ,? I have one 15000 domestic duo acc unit . ThanksSent from my iPhone using Tapatalk
Posted: 3:29 PM – Mar 08, 2019Can’t advise you on that one. I’m surprised no one else has chimed-in. I didn’t even know it was adjustable. The 15 second has worked
for me for the 7 years I have had the EMS. My remote pendant is inside, however, I an hear the definite click the unit makes once it
energizes the RV.Posted: 7:14 PM – Mar 08, 2019If I understand correctly, I think the delay is for the acc unitSent from my iPhone using Tapatalk
Posted: 9:49 AM – Mar 16, 2019Yup, the extended delay is to protect the air conditioner. I have mine set for the delay, it’s a bit over two minutes.Posted: 12:50 PM – Mar 17, 2019Check your ac model specs. Some have the delay built in; a 2nd delay is not really needed unless you want it. BriskAirII models have it built in.In certain storm areas, the second delay is a good idea to prevent domestic refrigerators and microwaves from blipping on and off.
papacliff wrote:Yup, the extended delay is to protect the air conditioner. I have mine set for the delay, it’s a bit over two minutes.Posted: 2:31 PM – Mar 17, 2019Ok thanks , looks like my original carrier has been replaced with the dometic , not sure on model but think it maybe the original brisk air and not the air 2 , need to checkSent from my iPhone using Tapatalk
Posted: 8:32 PM – Apr 09, 2019Still haven’t had time to install but going to next few days , another question I have , I sometimes use a 20 amp 110 cord to run fridge before we go camping , can you still do that after installing ems-hw50c without error Code coming up ?Sent from my iPhone using Tapatalk
Posted: 9:52 PM – Apr 09, 2019I have done so without issueB.W.Gentry
Owner/Admin
2007 Carri-Lite XTRM5
Breckenridge, TX
- You must be logged in to reply to this topic.